tag:blogger.com,1999:blog-7106903715458714896.post4224472755753589943..comments2023-09-10T01:26:35.654-07:00Comments on J,J&M's Westfield Builds and Ownership: Engine in then out again!jonjh1964http://www.blogger.com/profile/04671340399238982183noreply@blogger.comBlogger4125tag:blogger.com,1999:blog-7106903715458714896.post-55724361191717864382012-06-03T00:32:48.834-07:002012-06-03T00:32:48.834-07:00It's the engine mount for the n/s by the start...It's the engine mount for the n/s by the starter motor, the markings correspond to the slots on the chassis, if you look in the picture above you can see it under the rubber vibration absorber. I thought it should have come drilled, but it didn't, and I want to check the top right hole with Mark before I drill it. After all there's no rush!!!jonjh1964https://www.blogger.com/profile/04671340399238982183noreply@blogger.comtag:blogger.com,1999:blog-7106903715458714896.post-83869685339411102412012-06-02T23:34:13.593-07:002012-06-02T23:34:13.593-07:00Wish I had a dash to work on ! LOL
What is the pic...Wish I had a dash to work on ! LOL<br />What is the picture to the left of the tunnel gearbox mount ?<br />Great progress<br />Paul.Bromleyshttps://www.blogger.com/profile/05076830759951111085noreply@blogger.comtag:blogger.com,1999:blog-7106903715458714896.post-4587573369511127682012-06-02T02:15:24.535-07:002012-06-02T02:15:24.535-07:00Handbrake cable delivered by FedEx this morning at...Handbrake cable delivered by FedEx this morning at 08:30, still waiting on the ECU/Loom/TBs etc, no luck just getting the loom (so far!)as they come from OMEX as a complete kit. I was hoping that the instruments and missing switch would arrive so we could work on the dash - hopefully next week!!!!! I Might get the bodywork down during the week and start doing a trial fit.<br /><br />Jonjonjh1964https://www.blogger.com/profile/04671340399238982183noreply@blogger.comtag:blogger.com,1999:blog-7106903715458714896.post-89576013389104605122012-06-01T23:07:43.370-07:002012-06-01T23:07:43.370-07:00Going great guns ! you must be a nightmare for Wes...Going great guns ! you must be a nightmare for Westfield and their supply chain ! LOL<br />Did you get an ecu loom ?<br />Best wishes<br />Paul & Joe IOM.Bromleyshttps://www.blogger.com/profile/05076830759951111085noreply@blogger.com